sPOD BantamX Wireless Switch Controller | 8-Circuit | 2007–2018 Jeep Wrangler JK

Most JK builds outgrow their factory wiring before the second accessory goes in. Relay banks stack up, fuse panels get overloaded, and cab clutter compounds with every added circuit. The sPOD BantamX Wireless (Part #870120) eliminates that problem entirely. Eight independently switched, app-controlled circuits replace the relay bank, consolidate your power distribution into a single hub-centric module, and give you real-time wireless control over every accessory on the vehicle — from a 50" light bar to a twin-motor air compressor — without a single toggle switch on the dash.

Built in the USA, powdercoat-finished for corrosion resistance, and backed by a 5-year manufacturer warranty. This is the power management solution the JK platform should have shipped with from the factory.

Technical Specifications

• Part Number: 870120
• Circuits: 8 independent switched circuits
• Control Method: Wireless app-based (iOS & Android)
• Housing Finish: Powdercoat Black
• Country of Origin: USA
• Weight: 5.0 lb
• Dimensions: 13.0 × 10.0 × 10.0 in
• Warranty: 5-Year Manufacturer Warranty
• Sold As: Each

Verified Fitment (OFAS Standard)

• ✅ Fits: 2007–2018 Jeep Wrangler JK — 2-Door & 4-Door Unlimited
• ❌ Does NOT fit: 2018–2026 Jeep Wrangler JL — incompatible chassis architecture and electrical integration points; requires JL-specific BantamX harness
• ❌ Does NOT fit: 2020–2026 Jeep Gladiator JT
• ❌ Does NOT fit: 1997–2006 Jeep Wrangler TJ

Installation Notes

• Professional electrical installation strongly recommended; verify per-circuit amperage load against accessory draw ratings before final wiring
• Early JK (2007–2011) vs. late JK (2012–2018) may present minor harness routing differences — confirm sub-model year before ordering
• Confirm available mounting real estate in engine bay or cab prior to purchase
• Do not substitute JL-specific sPOD harness kits — connector and pinout configurations are not interchangeable
• Torque all terminal connections to manufacturer spec; loose connections under high-draw loads are a primary failure point in aftermarket power distribution installs

Talk to a Build Specialist: Running simultaneous high-draw loads across multiple circuits — dual compressors, light bars, and a winch on the same module? Contact OFAS to confirm circuit amperage allocation, fusing strategy, and wire gauge requirements for your specific JK build before you order.